CyberPower PDU15SW8RNET Manual do Utilizador descarregar pdf (Página 37)

PowerPanel™ Business Edition

 Negotiation: The Client is attempting to communicate with the power device at the specified

network address. Negotiation may take 5-20 seconds. Clicking the red X icon can stop the

negotiation process.

Clicking the red X icon can stop the negotiation process

Note: The communication between Client and power device can be cut off in Client. Clear the IP address

and then click Apply button to send a request from the Client to cancel the communication.

Easy-to-Setup Device IP

The uptime of the PDU indicates the length of time that the device has been functioning. When the Client

scans the local network and updates the device list, the PDU with the uptime reset will be marked a yellow

star icon.

Pressing the Reset button for 1 second can reset the PDU uptime. Do not press the reset button for

more than 4 seconds. Otherwise, all PDU settings will be reset to their default state.

A device with recently reset is marked with a yellow star icon.

Troubleshooting the Client’s inability to communicate with the power device:

z Verify the device network address is correct.

z Verify the network configuration for the device is correct. The Power Device Network Utility tool can be

used to configure the device network configuration. The tool can be installed from the tools folder on the

installation CD.

z Verify that the settings in the Security/Authentication page are correct and match the settings of the

device. See Security/Authentication f

or more details.

z Verify the port in the Security/Network page is matched if the power device is Agent. An unmatched

port results in communication failure or loss.

z Check that the network status of Clients and power devices.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 99 100

Sem comentários

CyberPower PDU15SW8RNET Manual do Utilizador Página 37